General Services

  • Drawing Preparation & Certification
  • Cost Estimates & Budgeting
  • Feasibility Studies & Reports
  • Site Inspection Reports
  • Green Building Design
  • Progress Claims
  • Cost Benefit Analysis
  • Pre-Purchase Inspection Reports
  • Shop Drawing Package Reviews
  • Energy Efficiency & Conservation Studies
  • Tendering Services & Specifications
  • Building Equipment Retrofits
  • Troubleshooting and Analysis

Mechanical Engineering

  • Heating, Ventilation & Air Conditioning (HVAC)
  • Air Handler Unit (AHU) Equipment Sizing
  • Building Management Systems & Controls
  • Essential Cooling Systems
  • Indoor Air Quality (IAQ)
  • Ventilation & Exhaust Systems
  • Boiler & Hydronic System Sizing and Design
  • Pump Sizing & Schematics
  • Fire Protection Systems
  • Fall Restraint Support Systems
  • General Plumbing Design Services
  • Domestic Hot Water Heating
  • Domestic Hot, Cold & Return Water Sizing
  • Sanitary Waste, Vent & Weeping Tile Sizing
  • Roof Water Drainage & Handling
  • In-Slab & Radiant Heating Systems
  • Storage and Pressure Tank Sizing
  • Sump Pump & Storage Tank Sizing
  • Lifting Devices & Mechanisms

Electrical Engineering

  • High Voltage Power Distribution
  • Light & Lighting Control
  • Low Voltage Power Distribution
  • Security Systems & Lighting
  • Lighting Analysis & Renderings
  • Fire Alarm Verification
  • Fire Alarm Systems
  • Voice and Data Systems
  • Emergency Generation Systems
  • Custom Printed Circuit Boards
  • Automotive Electronics
  • Solar and Other Renewable Systems

NECB Compliance

  • Full Building Energy Modelling
  • Preliminary Equipment Sizing & Recommendations (Including Design-Build Assistance)
  • Lighting Prescriptive & Trade-off Compliance Path Calculations
  • HVAC Prescriptive & Trade-off Compliance Path Calculations
  • Service Water Heating Prescriptive & Trade-off Compliance Calculations
  • Electrical Power Systems Prescriptive Compliance Calculations
  • Engineer-Stamped Compliance Documentation & Declarations Suitable For Permit Submission
  • General Public Education About NECB & Related Design Issues

Z32 Design & Testing

908 Engineering Inc. is pleased to announce the addition of CSA Z32 (Electrical safety and essential electrical systems in health care facilities) receptacle testing and design to our available services. Primarily serving Central Alberta, we can also provide CSA Z32 testing at any location in Canada.

Refer to the following document for requirements and testing procedures:

Z32 TESTING GUIDELINE

Refer to the following document for a suggest field wiring guide / schematic:

Z32 FIELD WIRING SCHEMATIC (Revised 29-Feb-2016)

Please be sure to Contact Us to inquire into any other services not listed above.